Service programmes, Descaling – Siemens TK76K573 User Manual
Page 53
51
de
en
Service programmes
At certain intervals, depending on how the
appliance is used, the display will show one
of the following texts instead of the coffee
selection:
Service - Calc‘n‘Clean
» i-button 3 sec.
¡
Service - descale
» i-button 3 sec.
¡
Service - clean
» i-button 3 sec.
¡
Service - change filter
» i-button 3 sec.
¡
Then the water filter should be changed im-
mediately or the appliance cleaned or des-
caled using the corresponding programme
(described on the next pages)� Otherwise
the appliance may be damaged�
The service programmes can also
be started manually in the settings
menu (see “Displaying settings”)�
Do not drink the liquids� Never use vinegar,
vinegar-based products, citric acid or citric
acid-based products for descaling� For
cleaning and descaling only use the tablets
intended for such� They were specially
developed for this fully automatic espresso
machine, and replacements are available
from retailers or customer service (see
“Accessories”)�
Never put descaling tablets or any other
descaling agents in the drawer for ground
coffee/cleaning tablets�
Never interrupt the service programme�
If one of the service programmes is inter-
rupted, e�g� by a power outage, proceed as
follows:
1� Rinse the water tank (12) and refill it
with fresh water up to the “max” mark�
2� Press
start stop (8)� The cleaning
programme will now run for about three
minutes�
Cleaning
Descaling
Important: If there is a filter in
the water tank (12), it needs to
be removed before the service
programme is run and should only
be replaced once the programme
is finished.
If the prompt
Service - descale
is dis-
played, press and hold down
i
(7) for at
least three seconds� The display shows:
Please press ‘Start/Stop’ to begin...
Descaling program
or
To start without the prompt (see “Displaying
Settings”) press and hold down
i
(7) for
at least three seconds and select
Please press ‘Start/Stop’ to begin...
Descaling program
Press
start stop (8)� The display
will guide you through the programme�
Empty drip tray
Empty the drip tray (20)�
Replace drip tray
Replace the drip tray�
If the milk frother is not inserted,
the following message is
displayed:
Set up milk frother
Insert the milk frother (10)�