Siemens TK76K573 - Manual (Page 47)

45
de en
Information and settings
Use i (7) to display information (press
briefly) and adjust settings (hold down for at
least three seconds)�
Displaying information
In the Info menu (press i (7) briefly) you
can call up the following information:
► when it is necessary to descale the
appliance
► when it is necessary to clean the
appliance
► when it is necessary to change the filter
► how much coffee has been dispensed
since the appliance was first put into
operation
► how many milk drinks have been
dispensed
► how much hot water has been prepared
....................................................................................
Information / Service
Descale after
100 cups
Displaying settings
Hold down i (7) for at least 3 seconds;
the different setting options are then
displayed:
Language:
English
Per-cup quantities
Default settings
Use < and > (3) to switch between
the different setting options� The currently
active setting is always highlighted in white�
You can change the setting that is currently
displayed by turning the rotary knob (4)�
To exit the menu, press i (7) again�
The changes you have made
are saved automatically� It is
not necessary to confirm them
additionally�
The following setting options are available
to you:
> Language : Turn the knob (4) to
select the display language�
> Per-cup quantities : The per-cup
quantity can be set separately for each
type of drink and each cup size (see “Set
per-cup quantity” on page 46)�
> Water hardness : Turn the knob
(4) to select the required water hardness
(1, 2, 3 or 4) (refer also to “Checking and
setting the water hardness”)�
> Coffee temperature : Turn the knob
(4) to set the coffee temperature�
> Auto off after : Turn the knob
(4) to enter the time span after which the
appliance should automatically switch off
following the last drink preparation� A time
between 5 minutes and 8 hours can be set�
The default time is 30 minutes, but this can
be shortened to save energy�
> Contrast : The display contrast can
be set from –20 to +20 with the rotary knob
(4)� The default setting is 0�
> Illumination : The lighting can be
set to Off , On or Off after 5 min. (factory
setting: On )�
> Water filter : Each time a new water
filter is inserted in the water tank (12), it
must be rinsed:
1� Place the water filter in the water tank
(12) and fill the tank with water up to the
“max” mark�
2� Turn the rotary knob (4) to select
Press start and press start stop
(8)�
3� Place a container with a capacity of
0�5 litres under the milk frother (10)�
4� Press start stop (8)� Water will now
run first through the filter to rinse it and
then into the container�