Odours, Light (led), Tips for saving energy – Siemens KI25RP60 User Manual
Page 28: If required, use an insulating plate, Open the appliance as briefly as possible, Operating noises, Quite normal noises, Droning, Bubbling, humming or gurgling noises, Clicking
en
28
Odours
If you experience unpleasant odours:
1. Switch off the appliance with the
On/Off button. Fig. "/5
2. Take all food out of the appliance.
3. Clean interior (see chapter “Cleaning
the appliance”).
4. Clean all packages.
5. Seal strong smelling food in order
to avoid odours from forming.
6. Switch the appliance on again.
7. Store food in the appliance.
8. Check whether the formation
of odours is still occuring after
24 hours.
Light (LED)
Your appliance features a maintenance-
free LED light.
These lights may be repaired
by customer service or authorised
technicians only.
Tips for saving energy
■
Install the appliance in a dry, well
ventilated room! The appliance should
not be installed in direct sunlight
or near a heat source (e.g. radiator,
cooker).
If required, use an insulating plate.
■
Allow warm food and drinks to cool
down before placing in the appliance.
■
Thaw frozen food in the refrigerator
compartment and use the low
temperature of the frozen food to cool
refrigerated food.
■
Open the appliance as briefly as
possible.
■
To prevent increased power
consumption, occasionally clean
the ventilation opening with a paint
brush or vacuum cleaner.
■
The arrangement of the fittings does
not affect the energy rating of the
appliance.
Operating noises
Quite normal noises
Droning
Motors are running (e.g. refrigerating
units, fan).
Bubbling, humming or gurgling noises
Refrigerant is flowing through the tubing.
Clicking
Motor, switches or solenoid valves are
switching on/off.
Preventing noises
The appliance is not level
Please align the installation cavity with
a spirit level. To do this, use the height-
adjustable feet of the cavity or place
something underneath.
Containers or storage areas wobble
or stick
Please check the removable parts
and re-insert them correctly if required.
Receptacles are touching each other
Move the receptacles slightly away from
each other.