Notes, Interior fittings, Taking out the glass shelf “easylift – Siemens KI25RP60 User Manual

Page 27: Taking out the door shelf “easylift, Taking out the fixed glass shelf, Removing the container, Remove telescopic rails, Installing telescopic rails, En 27

Proceed as follows:
1. Before cleaning: Switch off

the appliance.

2. Pull out mains plug or switch off fuse.
3. Take out the food and store in a cool

location. Place ice pack (if available)

on the food.

4. Wait until the layer of frost has thawed.
5. Clean the appliance with a soft cloth,

lukewarm water and a little pH neutral

washing-up liquid. The rinsing water

must not run into the light or through

the drainage hole into the evaporation

pan.

6. Wipe the door seal with clear water

only and then wipe dry thoroughly.

7. After cleaning reconnect and switch

the appliance back on.

8. Put the food back into the appliance.

Notes

■

Regularly clean the condensation

channel and drainage hole, Fig. )/B,

with a cotton bud to ensure that

the condensation can drain.

The water conduction channel,

Fig. )/A, can be taken out for

cleaning.

■

After cleaning, the stopper must be

re-inserted into the drainage hole

of the refrigerator compartment for

functional reasons.

Interior fittings

All variable parts of the appliance

can be taken out for cleaning.
Taking out the glass shelf “EasyLift”

Fig. %
Move glass shelf all the way upwards

and take out.
Taking out the door shelf “EasyLift”

Fig. &
Move door shelf all the way upwards and

take out.
Taking out the fixed glass shelf

Fig. '
Press buttons on the underside and

detach from the fixing.
Removing the container

Fig. *

Tilt container forwards and take out.
To insert the container, place the front

of the container on the telescopic rails

and push into the appliance.

The container is engaged by pushing

it into the appliance.
Remove telescopic rails

Fig. ,
1. Pull out the telescopic rail.
2. Push lock in the direction of the arrow.
3. Detach telescopic rail from the rear

pin.

4. Push telescopic rail together, push

backwards above the rear pin

and disengage.

Installing telescopic rails
1. Place the extended telescopic

rail on the front pin.

2. Pull the telescopic rail forwards

slightly until it engages.

3. Place telescopic rail on the rear pin.
4. Push lock backwards.