9 auto repeat mode off – Matrix Orbital PK162-12 User Manual
Page 43

Syntax
Hexadecimal
0xFE 0x7E [mode]
Decimal
254 126 [mode]
ASCII
254 “~” [mode]
Parameters
Parameter
Length
Description
mode
1
Auto Repeat Mode (0: Resend Key
, 1: Key Up/Down)
Description
Two auto repeat modes are available and are set via the same command:
•
Resend Key Mode: 0x00
•
Key Up/Down Mode: 0x01
Resend Key Mode
This mode is similar to the action of a keyboard on
a PC. In this mode, when a key is held down, the key code is
transmitted immediately followed by a 1/2 second delay. After
this delay, key codes will be sent via the RS-232 interface at a rate
of about 5 codes per second. This mode has no effect if polling or
if using the I
2
C interface.
Key Up/Down Mode
This mode may be used when the typematic pa-
rameters of the “Resend Key Code” mode are unacceptable or if
the unit is being operated in polled mode. The host system detects
the press of a key and simulates an auto repeat inside the host sys-
tem until the key release is detected. In this mode, when a key is
held down, the key code is transmitted immediately and no other
codes will be sent until the key is released. On the release of the
key, the key release code transmitted will be a value equal to the
key down code plus 20 hex.
Remembered
Yes
Examples
When the key code associated with key ’P’ (0x50) is pressed, the release
code is ’p’ (0x70). In RS-232 polled mode or via the I
2
C, the “Key
Down / Key Up” codes are used; however, the user should be careful of
timing details. If the poll rate is slower than the simulated auto-repeat it
is possible that polling for a key up code will be delayed long enough
for an unwanted key repeat to be generated.
9.9 Auto Repeat Mode Off
Syntax
Hexadecimal
0xFE 0x60
Decimal
254 96
ASCII
254 “‘”
Matrix Orbital
PK162-12
39