Matrix Orbital GLK12232-25-FGW - Manual (Page 47)

Description This command sets the display’s contrast to [contrast], where [contrast]
is a value between 0x00 and 0xFF (between 0 to 255). Lower values
cause ‘on’ elements in the display area to appear lighter, while higher
values cause ‘on’ elements to appear darker. Lighting and temperature
conditions will affect the actual value used for optimal viewing.
Individual display modules will also differ slightly from each other in
appearance. In addition, values for optimal viewing while the display
backlight is on may differ from values used when backlight is off.
This command does not save the [contrast] value, and is lost after power
down; but this command has the option of remembering the settings
when issued with the Remember function ‘on’ . When this is the case,
this command is the same as the Set and Save Contrast command.
Remembered Yes
Default 128
11.8 Set and Save Contrast
Syntax Hexadecimal 0xFE 0x91 [contrast]
Decimal 254 145 [contrast]
Parameters Parameter Length Description
contrast 1 Contrast value (0 to 255).
Description This command sets the display’s contrast to [contrast], where [contrast]
is a value between 0x00 and 0xFF (between 0 to 255). Lower values
cause ‘on’ elements in the display area to appear lighter, while higher
values cause ‘on’ elements to appear darker. Lighting conditions will
affect the actual value used for optimal viewing. Individual display
modules will also differ slightly from each other in appearance. In
addition, values for optimal viewing while the display backlight is on
may differ from values used when backlight is off.
NOTE This command saves the [contrast] value so that it is not lost after power down.
Remembered Yes
Default 128
12 Filesystem
12.1 Introduction
The GLK12232-25 incorporates a 16 Kbyte on board flash memory in order to allow font and bitmap
files to be transfered directly onto the display and recalled whenever necessary. The filesystem can address
Matrix Orbital GLK12232-25 42