MagTek P-SERIES USB - Manual (Page 13)

5
SECTION 2. INSTALLATION
This section describes the cable connection, the Windows Plug and Play Setup, and the physical
mounting of the unit.
USB CONNECTION
Connect the optional USB cable to a USB port on the host. The readers and pin numbers for the
cable connectors are shown in Figure 2-1 and Figure 2-2. The optional MagTek or user-supplied
cable is attached to J1 on either model.
Figure 2-1. Cabling for 21065128
The 5-pin connections (on J1) between the Reader and the USB connector shown in the
illustration are listed in Table 2-2.
Table 2-1. 5-Pin Connector (J1)
Pin Number Signal Cable Color
1 V
CC
Red
2 - Data White
3 +Data Green
4 Ground Black
5 Shield Ground Black