Videotec NTM - Manual (Page 7)

EN - English - I
nstruc
tions manual
5
Feed the cables through the cable grip, and make the
necessary electrical connections, ensuring that the
cable grips are holding firmly.
6.1.2.1 Version 12Vdc/24Vac
When the power supply voltage is 24Vac the circuit
will be connected by the terminals shown.
Heater OUT 12Vdc/24Vac OUT 12Vdc/24Vac
IN 12Vdc/24Vac
Fig. 04
6.1.2.2 Version 115/230Vac
When the power supply voltage is 115/230Vac the
circuit will be connected by the terminals shown.
OUT 115/230Vac
IN 115/230Vac
Heater OUT 115/230Vac
Fig. 05
Before closing the housing reinsert the bottom
orientating the slide according to the installation
required, on the wall bracket (Fig. 06, page 6) or on the
Pan & tilt (Fig. 07, page 6) head, for the right camera
fitting.
Close the housing, taking care not to damage the
seals (ensure that they are correctly fitted in their
respective positions).
6 Assembling and
installing
g h Only specialised personnel should be
allowed to assemble and install the device.
6.1 Installation
6.1.1 How to open the housing
To open the housing, unscrew the bolts on the front
bottom, using the hexagonal spanner supplied.
Fig. 01
Remove the bottom of the housing.
Fig. 02
6.1.2 How to install the camera
This chapter described how to install the camera into
the housing.
Open the housing as described previously.
Fit the camera on the slide, using the insulating plate
and the supplied 1/4” screw. If necessary, use the
spacers to position the camera and optics correctly.
Fig. 03