Videotec NTM - Manual (Page 6)

EN - English - I
nstruc
tions manual
4
5 Preparing the product
for use
g h Any change that is not expressly approved
by the manufacturer will invalidate the
guarantee.
5.1 Contents and unpacking
When the product is delivered, make sure that the
package is intact and that there are no signs that it
has been dropped or scratched.
If there are obvious signs of damage, contact the
supplier immediately.
Keep the packaging in case you need to send the
product for repairs.
Check the contents to make sure they correspond
with the list of materials as below:
• NTM housing
• Housing equipment:
• Allen wrench
• Spacers
• Screws and washers
• Screws for camera
• Instructions manual
5.2 Safely disposing of
packaging material
The packaging material can all be recycled. The
installer technician will be responsible for separating
the material for disposal, and in any case for
compliance with the legislation in force where the
device is to be used.
Bear in mind that if the material has to be returned
due to a fault, using the original packaging for its
transport is strongly recommended.
4 Identification
4.1 Product description and type
designation
The NTM housing, entirely constructed from AISI 316
electropolished stainless steel, is equipped with a
Germanium viewing window designed for thermal
camera installations. The clear Germanium glass
composition with remarkable properties covers
transmission from 7.5 to 14μm IR range with the best
optical quality. The window dimension allows the
installation of different cameras/lens combination.
NTM is designed to operate in special environments
such as marine, industrial, chemical and where the
external agents are highly corrosive.
The NTM housing consists of a 130mm diameter
cylindrical body enclosed by two 9mm thick circular
flanges. The back flange is equipped with two PG13.5
cable glands for the external connections.
A wide range of accessories is available: sunshield,
heater, stainless steel brackets and wiper-washer.
4.2 Product markings
See the label attached to the outside of the package.