Videotec ULISSE COMPACT HD - Manual (Page 11)

Instruc
tions manual - English - EN
11 MNVCUCHD_1405_EN
6.1.2 Fixing the base to the support
Use the screws and the washers supplied
with the base.
After having positioned gasket (01), fasten base (02)
on support (03) using screws (04), toothed spring
washers (05) and the flat washers (06). Insert the
screw-sealing OR (07).
01
06
07
05
02
03
04
Fig. 5
03
01
07
02
06
05
04
Fig. 6
Align the 3 notches on the base with those on the
support as shown in the following figure.
Fig. 7
Apply a generous amount of thread locking
compound into the screw holes (Loctite
243®).
Pay attention to the fixing. Tightening
torque: 4Nm max.
6.1.3 Connection of the connector
board
6.1.3.1 Board description
BOARD DESCRIPTION
Connector Function
J2 Board power supply (V
IN
)1
Tab. 1
J2
Fig. 8