Appendix b—specifications, Hardware interface, Lan interface – Teledex Y Series User Manual
Page 20: Adsl, Wlan, Bridge functions, Management, Power supply, Certifications, Packing accessories
20
www.teledex.com
Y SERIES EXA100 USER GUIDE
Appendix B—Specifications
Hardware Interface
• Power Jack x 1
• Two Punch IDC Connectors
• Reset Button x 1
• Active LED x 2
• Antenna Internal
LAN Interface
• IEEE 802.3, IEEE 802.3u
ADSL
• ADSL Standard ITU-T G.992.5, ITU-T G.992.3,
ITU-T G.992.1, ANSI T1.413 Issue 2
• G.992.5 (ADSL2+)
• G.992.3 (ADSL2)
• G.DMT
WLAN
• IEEE 802.11n, Backward Compatible with
802.11g/b
• 64, 128-bit Wired Equivalent Privacy (WEP)
Data Encryption
• 11 Channels (US, Canada)/13 Channels
(Europe)/14 Channels (Japan)
• Up to 300 Mbps Data Rate
• WPA / WPA2
• IEEE 802.1x
• RF Operating Frequency: 2.412-2.497 GHz
(2.4 GHz ISM Band)
• ddRF Output Power: 15dBm
• Antenna Gain: 2dBi
Bridge Functions
• IEEE 802.1d
• VLAN Support
• Spanning Tree Algorithm
• IGMP Proxy
Management
• SNMP, Telnet, Web-Based Management,
Configuration Backup and Restoration
• RFC1213 Management Information Base
for Network Management of TCP/IP-Based
Internets: MIB-II
• Software Upgrade via HTTP
Power Supply
• Input: 100 - 240 Vac
• Vac/50-60Hz
• Output: 12 Vdc/1 A
Certifications
• EN 55022 + EN55024
• EN 300328
• EN 301489-1/-17
• EN 60950-1
• Power Saving
• WEEE
• RoHS
• REACH
Packing Accessories
• Module x 3
• Quarter Blank Spec x 2
• KeyStone Jack x 1
• Connector Switch x 1
• QIG for Troubleshooting
• Water-Proof Sealed PE Bag (for ATU-R&QIG)
x 1
NOTE: Specifications are subject to change
without notice.