Teledex Y Series - Manual (Page 13)

Y SERIES EXA100 USER GUIDE www.teledex.com 13
5.3.1 SELECT SSID
SSID Choice: Select SSID from the drop-down list.
5.3.2 “DEFAULT”
Security Mode: There are 11 options, including
Disable, OPEN, SHARED, WEPAUTO, WPA, WPA-
PSK, WPA2, WPA2-PSK, WPAPSKWPA2PSK,
WPA1WPA2, and 802.1X.
5.3.3 [EXAMPLE]
Take Open WEP for example. Select Open WEP
from the
Security Mode drop down-list. The
following page will be displayed.
5.3.4 CETIS AP
Security Mode: There are 11 options, including
Disable, OPEN, SHARED, WEPAUTO, WPA, WPA-
PSK, WPA2, WPA2-PSK, WPAPSKWPA2PSK,
WPA1WPA2, and 802.1X.
5.3.5 WIRE EQUIVALENCE PROTECTION
(WEP)
WEP Key (1-4): Input the key to encrypt wireless
data. To allow encrypted data transmission,
the WEP Encryption Key values on all wireless
stations must be the same as the router. There
are four keys for your selection. The input format
can either be HEX style or ASCII format, 10 and 26
HEX codes or 5 and 13 ASCII codes are required
for WEP64 and WEP128 respectively.
5.3.6 ACCESS POLICY
Policy: There are three options, including Disable,
Allow, and Reject. You can choose Disable, Allow,
or Reject. Select Allow, only the clients whose
MAC address is listed can access the router.
Select Reject, the clients whose MAC address is
listed are denied to access the router.
Add a Station MAC: If you want to add a station
MAC, input the MAC address of the wireless
stations that are allowed or denied access to your
router in this address field.
After completing the settings above, click Apply to
save the settings and make the new configuration
take effect. Click
Cancel to close without saving.
5.4 WDS
5.4.1 WIRELESS DISTRIBUTION SYSTEM
(WDS)
WDS Mode: There are four options, including
Disable, Lazy Mode, Bridge Mode, and Repeater
Mode.
•
Disable
Select Disable to disable the WDS mode.
• Lazy Mode