Teledex E Series - Manual (Page 26)

26 www.teledex.com E SERIES ANALOG USER GUIDE
pressing the ON/OFF key. The ON/OFF indicator
of the other handsets will flash to display the
phone is in use.
SPEED DIALING FROM THE HANDSET
The handset can access 6 different speed dial
numbers programmed in the base.
Pressing down the 1 key for 3 seconds will call
the number stored in Message on the base unit.
Press down the 2 key for 3 seconds to call the
number stored in M2 on the base unit.
Press down the 3 key for 3 seconds to call the
number stored in M3 on the base unit.
Press down the 4 key for 3 seconds to call the
number stored in M4 on the base unit.
Press down the 5 key for 3 seconds to call the
number stored in M5 on the base unit.
Press down the 6 key for 3 seconds to call the
number stored in M6 on the base unit.
If the base unit cannot store any number, these
operations can only pick up with the handset.
Programming
PROGRAM SPEED DIALS USING
SUBMERGED [STORE] AND [FLASH]
[Store] and [Flash] programming keys are located
under the faceplate and overlay; begin by lifting
up faceplate and overlay, by either a paperclip or
sharp pointer.
STORING A NUMBER INTO MEMORY
KEYS—[STORE]
Each speed-dial location can store up to 24 digits
in tone mode.
Note: Flash programmed into memory counts as
one digit when storing a number.
1. Lift the handset.
2. Press the STORE key.
3. Enter the number to be stored using the
numeric dial pad.
4. Press the desired memory location where
the number is to be stored.
5. If additional numbers are to be stored,
repeat steps 3 through 5.
6. Hang up the handset.
PROGRAMMING FLASH TIMING
Flash timing options are 100 ms through 1000
ms, programmable in 100 ms increments. The
default Flash timing is 600 ms.
1. Lift the handset (off-hook position).
2. Press the STORE key once.
3. Program FLASH by pressing 1 for 100 ms,
2 for 200 ms, etc.
4. Press STORE.
5. Press FLASH.
6. Hang up the handset to exit programming.
PROGRAMMING PAUSE TIMING
Pause timing options are 1 second through 5
seconds, programmable in 1 second increments.
The default pause timing is 3.5 seconds.
1. Lift the handset (off-hook position).
2. Press the STORE key once.
3. Program Pause by pressing 1 for 1 second,
2 for 2 seconds, etc.
4. Press STORE.
5. Press PAUSE/REDIAL.
6. Hang up the handset to exit programming.
FLASH HOOK FUNCTION—[FLASH]
The Flash function is used to access PBX features
or Telco line features such as Call Waiting. The
Flash function is a 600 ms timed line break. If the
Flash function will be used often, store the feature
into memory located for easy access as follows:
1. Lift the handset then press the STORE key.
2. Press the FLASH key.
E203 AND E203 REDIDOCK PHONES