Teledex E Series - Manual (Page 16)

16 www.teledex.com E SERIES ANALOG USER GUIDE
3. For some PBX systems that provide
reverse polarity message signaling, it may
be necessary to move the switch to either
LR1 or LR2. The correct position of the
switch will cause the message lamp to be
on continuously when a message is in the
mailbox.
PAGE
CALL THE HANDSET
Press the base unit’s Page key to call the handset,
and the handset’s message and On/Off indicator
lights flash. Press the Page key again or any
key in the handset or place the handset into the
cradle to end the page.
REGISTERING A HANDSET
Auto-Sync Handset Registration
Pairing the handset to the base is an easy
process that should need to be performed only
once. After installing the battery, and securing
the cover with the 2 screws provided, place the
handset into the base unit cradle and make sure
the charging leads make contact. The LED above
Line 1 will light up and begin to blink rapidly,
as the base and the handset enter Registration
mode. The Registration process may take as long
as 1 minute to complete, as the handset and base
station exchange large amounts of encoded data.
When the base and the handset have successfully
paired, the phone will beep a Registration
confirmation tone.
Each handset can sync with only ONE base
station at a time. When a handset gets moved
to a different base station, it will immediately
sync with the new base station. After this the
handset is no longer synced with its original base
station, which means that if a cordless handset is
accidentally moved into a different room, then the
handset will wind up synced with the base station
in the new room.
SWITCH BETWEEN BASE AND HANDSET
If the handset is registered with the base unit then
the handset and base can switch the call freely.
To switch from the handset to the base, press the
Speaker key in the base unit and then press the
On/Off key in the handset to switch from base to
handset.
SWITCH BETWEEN HANDSETS
Every base unit can register up to 4 additional
handsets. If one of the handsets is picking up
a call, any one of the other handsets can pick
up the call by pressing the On/Off key. The On/
Off indicator of the other handsets will flash to
display that the phone is in use.
SPEED DIALING FROM THE HANDSET
The handset can access 6 different speed-
dial numbers programmed in the base.
Pressing down the 1 key for 3 seconds will call
the number stored in Message on the base unit.
Press down the 2 key for 3 seconds to call the
number stored in M2 on the base unit.
Press down the 3 key for 3 seconds to call the
number stored in M3 on the base unit.
Press down the 4 key for 3 seconds to call the
number stored in M4 on the base unit.
Press down the 5 key for 3 seconds to call the
number stored in M5 on the base unit.
Press down the 6 key for 3 seconds to call the
number stored in M6 on the base unit.
Programming
PROGRAM SPEED-DIALS USING
SUBMERGED [STORE] AND [FLASH]
[Store] and [Flash] programming keys are located
under the faceplate and overlay. Begin by lifting
up faceplate and overlay using either a paperclip
or sharp pointer.
E103 AND E103 REDIDOCK PHONES