Teledex E Series - Manual (Page 17)

E SERIES ANALOG USER GUIDE www.teledex.com 17
STORING A NUMBER INTO MEMORY
KEYS—[STORE]
Each speed-dial location can store up to 24 digits
in tone mode.
Note: Flash programmed into memory counts as
one digit when storing a number.
1. Leave handset in cradle/on-hook.
2. Press the STORE key.
3. Enter the number to be stored using the
numeric dial pad.
4. Press STORE key.
5. Press the desired memory location where
the number is to be stored.
6. If additional numbers are to be stored,
repeat steps 2 through 5.
PROGRAMMING FLASH TIMING
Flash timing options are 100 ms through 1000
ms, programmable in 100 ms increments. The
default Flash timing is 600 ms.
1. Leave handset in cradle/on-hook.
2. Press the STORE key once.
3. Program Flash by pressing 1 for 100 ms, 2
for 200 ms, etc.
4. Press STORE key.
5. Press FLASH key.
PROGRAMMING PAUSE TIMING
Pause timing options are 1 second through 5
seconds, programmable in 1 second increments.
The default pause timing is 3.5 seconds.
1. Leave handset in cradle/on-hook.
2. Press the STORE key once.
3. Program PAUSE by pressing 1 for 1
second, 2 for 2 seconds, etc.
4. Press STORE key.
5. Press PAUSE/REDIAL key.
FLASH HOOK FUNCTION—[FLASH]
The Flash function is used to access PBX features
or Telco line features such as Call Waiting. The
Flash function is a 600 ms timed line break. If
the Flash function will be used often, store the
feature into memory located for easy access as
follows:
1. Leave handset in cradle/on-hook.
2. Press STORE key.
3. Press FLASH key.
4. Press STORE key.
5. Press the memory location where the
FLASH is to be stored.
MESSAGE WAITING AND RETRIEVAL
Pressing the touch bar automatically turns on
the speakerphone and then dials into a user-
programmed voice mail system to retrieve
messages.
1. Leave handset in cradle/on-hook.
2. Press STORE key.
3. Enter the number to be stored using the
numeric dial pad.
4. Press STORE key.
5. Press the red Message Waiting bar to
store.
In Case of Power Outage
The phone base will function without commercial
power (but the handset will not operate).
Ringer: When receiving a new call, the phone
base will ring, but not the handset.
Pick up: Press the line key to pick up/go off-hook.
Dial: Under off-hook status, the loudspeaker and
microphone will receive sound, and calls can be
placed using the dial pad.
E103 AND E103 REDIDOCK PHONES