Teledex E Series - Manual (Page 23)

E SERIES ANALOG USER GUIDE www.teledex.com 23
Unpacking Your Telephone
This package should contain the following:
• Telephone base unit
• Mobile handset
• Paper faceplate
• Protective plastic overlay
• Power adapter (direct connect -7.5 300mA)
• Handset battery
• Two rubber plugs for the handset cover
• Two screws to secure the top and bottom
handset
Optional items to be ordered separately:
• Handset package: charging station, power
adapter, battery, handset, 2 rubber plugs, and
2 handset screws
Installing the Phone
CAUTION INFORMATION
• Never install telephone or network wiring
during a lightning storm.
• Never install telephone or Ethernet jacks
in wet locations unless the jack is specially
designed for wet locations.
• Never touch uninstalled telephone wires or
terminals unless the telephone line has been
disconnected at the network interface.
• Use caution when installing or modifying
telephone and network lines.
• Be sure your power adaptor meets your
regions requirements prior to installation.
CONNECTING THE POWER LINE CORD
Two line cords are provided: one RJ45 and one
RJ11.
To install, simply plug one end of the RJ45 cord into
the modular jack at the top end of the base unit
and the other end into the RJ45 phone jack on the
power adaptor. Take the other RJ11 line cord and
plug into the line jack on the power adaptor, then
plug the other end into the wall. Finish by plugging
the power adaptor into normal wall outlet.
Be sure your power adaptor is specified for your
region of the world prior to plugging into the wall
socket.
HANDSET BATTERY
CHARGING THE HANDSET BATTERY (ON BASE
AND CHARGING STATION)
The handset battery is a Ni-MH battery. This
battery requires a full charge prior to use to
ensure long life. To charge the battery, complete
the installation procedure by plugging the power
source into the wall outlet and the telephone
base or charging station.
Install the battery per instructions, inserting
battery plug into receptacle.
Place the battery in the opening in the handset,
press into place, then replace cover, and place
handset into base (face down) or charging station
(face down).
BATTERY LIFE—WHEN COMPLETELY
CHARGED
• Talk time: 7.5 hours
• Standby (handset off hook): 6 days
• Charge for 24 hours to ensure a fully charged
battery
INSTALLING THE BATTERY INTO THE
HANDSET
1. Hold the handset and gently push up the
handset back shell.
2. Remove the back, exposing the battery
compartment.
3. Slide the battery plug into its receptacle,
matching up slot and opening on
receptacle.
4. Do not force the battery.
E203 AND E203 REDIDOCK PHONES