Texsport 14280 Seadrif Hammock Combo - Manual (Page 2)

STEP 7 - Attach tubular bar and
loop ring to the inserted v hooks. STEP 9 - Your new hammock is
ready to enjoy. STEP 8 - Tie the hammock pillow
to the header bar.
STEP 4 - Slide a tubular dowel (D)
through the sewn hem at each
end of the hammock. Insert the
dowel through the loop rings (H)
in the cutout portions of the ham-
mock. The loop and ring should
be on the same side as the
header bar. STEP 5 - Place the straight side of
a spiral/V hook (G) into the two
outer holes going completely
through the header tubing (B)
and out the bottom. The curved
portion of the spiral/V hook
should point toward the ham-
mock. Attached the chain to the v
hook. STEP 6 - Repeat step 4 and 5 for
the other side of the hammock
bed, but without the chain (part
H).
MAINTENANCE:
1.
For best results and longer life, store your stand out of the weather to reduce the possibility of rust.
2. BEFORE EACH USE, INSPECT ALL MOUNTING HARDWARE, STAND PARTS, POINTS OF CONNECTION AND YOUR HAMMOCK FOR INDICA-
TIONS OF TEAR OR DEFECTS, REPLACE ALL WORN PARTS PRIOR TO USE OF YOUR STAND OR HAMMOCK.
3. Should the painted surface become scratched or chipped, obtain a matching paint and touch up spots where the underlying metal is exposed to
inhibit rust.
CAUTIONS AND WARNINGS:
DO NOT let children or anyone else use the hammock or stand for a trampoline or swing. Swinging and roughhousing are dangerous and will wear
your hammock and stand much quicker than normal.
DO NOT allow the connections (where one part inserts into another part) to become loose or less than fully inserted. Inspect prior to every use to make
certain that parts are firmly connected.
DO NOT EXCEED THE SUGGESTED WEIGHT LIMIT FOR YOUR HAMMOCK. THESE WEIGHT LIMITS ARE INDICATED ON MOST HAMMOCKS.
QUESTIONS:
If you should have any questions, problems or comments, please call our Customer Service Department at
1-800-231-1402
or e-mail [email protected]. This Department is open M–F from 8 a.m.–5 p.m. CST.