Texsport 01250 The Lodge Tent - Manual (Page 3)

STEP 22 - Snap web strap buckels to-
gether and pull strap to tighten
around SUV. STEP 23 - Wrap tent fabric around
bumper to secure. STEP 24 - If you are not attaching an
SUV, unzip the SUV attachment
STEP 25 - To remove SUV attachment,
unzip and remove from tent skin. STEP 26 - Assemble the rear awning
poles. Use the short series of poles in
the order shown above. STEP 27 - The awning will not stand up
by itself until it is guy roped. First make
a small loop and tie a knot.
STEP 28 - At the other end of the guy
rope,
insert the guy rope through the
hole in the clew and tie a knot.
STEP 29 - Insert the pin of the assem-
bled awning pole into the grommet as
shown. STEP 30 - Wrap a section of guy rope
around the pin of the pole.
STEP 31 - Stake down the other end
with the loop. STEP 32 - Adjust the tension in the guy
rope by hooking the clew to the guy
rope. STEP 33 - Repeat steps 27 through 32
for the other awning pole. This is what
your tent should look like.
STEP 34 - To hang the utility net, locate
the loop tabs inside near the tent’s
roof. STEP 35 - Hook into all 4 loops.
C
I
E