Kenwood BDR-A7 - Manual (Page 51)

51
English
[BD PLAYER SECTION]
PROBLEM POSSIBLE CAUSE REMEDY
No playback • The disc is loaded upside down.
• The disc is not playable.
• The disc is dirty.
• The recorded disc is not correctly finalized.
• The parental level is not set correctly.
• The symbol about invalid operation is displayed.
• Reload the disc with the printed side up.
• Use a playable disc.
• Clean the disc.
• Load a disc that is correctly finalized.
• Set the parental level setting correctly.
(Refer to “SETTING THE PARENTAL CONTROL”
on page 44.)
• Adjust the setting correctly.
(Refer to “SYMBOL ABOUT INVALID OPERATION”
on page 25.)
Malfunction • The disc is scratched, dirty badly or unplayable. • Press the POWER ON/STANDBY button to turn the
power off, press this button again and then unload
the disc.
No picture • The video cords are disconnected.
• The incorrect selection of input source on the
TV.
• The disc is not playable.
• Connect the cords correctly.
• Select the input source correctly.
• Use a playable disc.
Noisy or distorted picture • The unit is connected to a VCR directly and the
copyguard function is activated.
• The disc is dirty.
• It is in rapid advance or reverse playback, or in
frame advance playback.
• Connect the unit so that the picture signal is
transferred directly to the TV.
• Clean the disc.
• Sometimes small amount of picture distortion may
appear. This is not malfunction.
Abnormal picture or no
picture • The unit is connected to a VCR directly and the
copyguard function is activated.
• The disc is dirty.
• It is in rapid advance or reverse playback, or in
frame advance playback.
• Set the resolution correctly. (Refer to “SETTING
THE DISPLAY” on page 42.)
• This unit will not transfer the video signals via HDMI
connector to TV that does not support HDCP.
This is not malfunction.
• Set the TV type correctly. (Refer to “SETTING THE
DISPLAY” on page 42.)
Slight pause of picture • The layer transition occurs during playback of
DVD Videos, etc. recorded in dual-layer format.
• Sometimes slight pause may occur.
This is not malfunction.
Noisy or distorted sound • The disc is dirty. • Clean the disc.
BD-LIVE contents cannot be
loaded • Poor connections between this unit and
broadband router and/or modem.
• The USB memory device is disconnected.
• The BD-Live Internet Access is set to “Prohibit
Access”.
• The BD disc does not support BD-LIVE.
• The network settings are not set correctly.
• Check the connections and connect all cords
securely.
• Connect the USB memory device to this unit.
• Set it to “Always Allow Access” (Refer to “SETTING
THE SYSTEM” on page 41.)
• Load a disc that supports BD-LIVE.
• Set the network settings correctly. (Refer to
“SETTING THE NETWORK” on page 45.)
BDR-A7_EN_CS3.indb 51 BDR-A7_EN_CS3.indb 51 11.3.10 6:59:43 PM 11.3.10 6:59:43 PM