Kenwood BDR-A7 - Manual (Page 12)

12
English
■ FUNCTION TABLE of the NUMBERED BUTTONS.
(for TV) (for Cable box)
(for Satellite
receiver)
1 POWER ON POWER ON POWER ON
2 STANDBY STANDBY STANDBY
3 MUTE MUTE MUTE
4 CHANNEL UP CHANNEL UP CHANNEL UP
5 CHANNEL DOWN CHANNEL DOWN CHANNEL DOWN
6 VOLUME
%
/
fi
VOLUME
%
/
fi
VOLUME
%
/
fi
7
INPUT
SELECTOR
INPUT
SELECTOR
INPUT
SELECTOR
8 NUMERIC NUMERIC NUMERIC
■ Notes :
• Some functions for each component may not
be available or may work differently.
• Depending on other kinds of components that
are available for each DEVICE button, some
functions may not be available or may work
differently, too.
• For details about functions, refer to the
operating instructions of each component.
• This remote control can control up to 3 different components.
• Before operating video components other than this unit with using this remote control, the setup code for each
component should be entered.
ENTERING A SETUP CODE
Device to be
controlled
Button symbol
1.
Turn on the component you want to operate.
2.
Find the setup codes according to the type and the
brand name of your component, referring to “Setup
Code Table” on page 54.
3.
Press and hold down both the OK button and the
DEVICE button you want for more than 1 seconds.
• The LED will flicker once.
■ Note :
• The MAIN button is unavailable for the components other
than this unit.
4.
Enter a 3 digit code.
Example: When entering “001”.
• If entering is performed successfully, the LED will flicker
twice.
• To be sure that the setup code is correct, press the ON (or
STANDBY) button, aiming the remote control at the remote
sensor on the component. If your component is turned off,
the setup code is correct.
• When your component is not turned off, repeat the above
steps 2 to 4, trying each code for your component until you
find one that works.
■ Notes :
• If the LED did not flicker twice, then repeat the above steps
3 to 4 and try entering the same code again.
• Manufacturers may use different setup codes for the same
product category. For that reason, it is important that you
check to see if the code you have entered operates as
many controls as possible. If only a few functions operate,
check to see if another code will work with more buttons.
5.
Repeat the above steps 1 to 4 for each of your
components.
: For TV
: For cable box
: For satellite receiver
BDR-A7_EN_CS3.indb 12 BDR-A7_EN_CS3.indb 12 11.3.10 6:59:35 PM 11.3.10 6:59:35 PM