Kenwood BDR-A7 - Manual (Page 47)

47
English
Operation of Tuner
LISTENING TO RADIO BROADCASTS
Auto tuning
1.
Select the desired FM mode.
• Each time this button is pressed, the FM mode changes
as follows :
FM ST ➝ FM MONO
(“ST” lights up) (“ST” goes off)
• When FM stereo broadcasts are poor because of
weak broadcast signals, select the FM mono mode to
reduce the noise, then FM broadcasts are reproduced in
monaural sound.
2.
Press the TUNING buttons for more than 0.5
second.
• The tuner will now search until a station of sufficient
strength has been found. The display shows the tuned
frequency and “TUNED”.
• If the station found is not the desired one, simply repeat
this operation.
• Weak stations are skipped during auto tuning.
Manual tuning
• Manual tuning is useful when you already know the
frequency of the desired station.
• After selecting the desired band, press the TUNING
buttons repeatedly until the right frequency has been
reached.
Auto presetting
• Auto presetting function automatically searches for FM
stations and store them in the memory.
• While listening to FM radio broadcasts, press and hold
down the OK button for more than 2 seconds.
• Then “AUTO MEM” flickers and this receiver starts auto
presetting.
• To stop auto presetting, press this button again.
• Up to 30 FM stations can be stored.
■ Notes:
• FM stations of weak strength cannot be memorized.
• To memorize weak stations, perform “Manual presetting”
procedure with using “Manual tuning” operation.
BDR-A7_EN_CS3.indb 47 BDR-A7_EN_CS3.indb 47 11.3.10 6:59:42 PM 11.3.10 6:59:42 PM