Kenwood BDR-A7 - Manual (Page 13)

13
English
• Use the remote control within a range of about 7 meters (23
feet) and angles of up to 30 degrees aiming at the remote
sensor.
■ Note :
• Remote operation may become unreliable if the remote
sensor is exposed to strong light such as direct sunlight or
inverted fluorescent.
1.
Remove the cover.
2.
Load two batteries (AAA size, LR03/24A) matching
the polarity.
1.
Enter the setup code for each component other
than this unit you wish to control. (For details, refer
to “ENTERING A SETUP CODE” on page 12.)
2.
Turn on the component you want to operate.
3.
Press the DEVICE button on the remote control
corresponding to the component you wish to
operate.
Example) When selecting “MAIN” to operate this unit.
4.
Aim the remote control at the REMOTE SENSOR
of the component you wish to control and press the
button corresponding to the operation you want.
OPERATING COMPONENTS WITH REMOTE
CONTROL REMOTE CONTROL OPERATION RANGE
LOADING BATTERIES
• When the remote control does not operate, the old batteries should be replaced. In this case, load new batteries within
several minutes after removing old batteries.
• If the batteries are removed or have been exhausted for a longer period of time, memorized contents will be cleared.
Should this happen, you should memorize them again.
¤ CAUTION
• Do not leave the battery near fire or under direct sunlight.
• A fire, explosion or excessive heat generation may result.
• Remove the batteries when they are not used for a long
time.
• Do not use the rechargeable batteries (Ni-Cd type).
• Be sure to use alkaline batteries.
7
BDR-A7_EN_CS3.indb 13 BDR-A7_EN_CS3.indb 13 11.3.10 6:59:35 PM 11.3.10 6:59:35 PM