Help – Kenwood DNX520VBT User Manual
Page 81
English 81
Help?
Error
When the unit fails to operate correctly, the cause
of the failure appears on the display.
"Protect" :
Protective circuit has been activated because a speaker
cord has shorted or it has come in contact with the car
chassis.
➡ Wire or insulate the speaker cord as appropriate
and then push the Reset button.
"Hot Error" :
When the internal temperature of this unit rises to 60°C
or more, the protection circuit is activated and you
may not be able to operate the unit. At such times this
message will appear.
➡ Use the unit again after reducing the
temperature inside the vehicle.
"Mecha Error" :
The disc player is malfunctioning.
➡ Eject the disc and try inserting it again. Contact
the Kenwood dealer if this indicator continues
blinking or the disc cannot be ejected.
"Disc Error" :
Disc is quite dirty.
➡ Clean the disc, referring tot he section on
Disc is upside down.
➡ Load the disc with the labeled side up.
An unplayable disc is inserted.
"Region Code Error" :
The disc you wanted to play has a region code that
cannot be played with this unit.
"Parental Level Error" :
The disc you wanted to play has a higher level than the
parental level you set.
"No Device" (USB device):
The USB device is selected as a source although no USB
device is connected.
➡ Change the source to any source other than USB.
Connect an USB device, and change the source
to USB again.
"Disconnected" (iPod):
The iPod is selected as a source although no iPod is
connected.
➡ Change the source to any source other than iPod.
Connect an iPod, and change the source to iPod
again.
"No Media File" :
The connected USB device contains no playable audio
file.
Media was played that doesn’t have data recorded that
the unit can play.
"USB Device Error!!" :
The connected USB device is rated a current capacity
higher than the allowable limit.
➡ Check the USB device.
Some trouble may have occurred to the connected
USB device.
➡ Change the source to any source other than USB.
Remove the USB device.
"Authorization Error" :
Connection to the iPod has failed.
➡ Remove the iPod and then reconnect it.
The unit does not support the iPod.
➡ Refer to this unit> (page 6). "Update your iPod" : The iPod's software is an older version which the unit ➡ Confirm that the software for the iPod is the latest version. Refer to "You only can connect one iPod." : More than one iPod are connected to this unit. ➡ Connect only one iPod to the USB terminal with iPod tag. "Navigation Error. Please turn on power again The communication error has occurred due to severely ➡ Turn on power again after warming your car interior. B64-4644-00_00_VW_E_En.indd 81 B64-4644-00_00_VW_E_En.indd 81 09.12.22 2:43:31 PM 09.12.22 2:43:31 PM
can not support.
later." :
cold temperature.