Audio control – Kenwood DNX520VBT User Manual
Page 54
54 DNX520VBT
Audio Control
Audio Control Menu
Displays the Audio Control menu to set the sound
effect function of this unit.
Display the Source Select Screen
1
SRC
Display the Audio Control menu
2
In this manual, the above selection is indicated
as:
Touch [
]
>
[
].
Select the Audio Control item
3
Item
Page
[Audio Control]
54
[Equalizer]
55
[Tone]
55
[Zone Control]
56
Audio Control
You can adjust the front/rear and right/left audio
balance.
Display the Audio Control screen
1
Touch [
]
>
[
]
>
[Audio Control]. (page 54)
Set each item
2
1
1
1
1 Adjusts the front/back and left/right balance
of the volume by touching the Adjust screen.
[
2], [3] Adjusts the right and left volume
balance.
[
5], [∞] Adjusts the front and rear volume
balance.
[VOL.Offset] Finely adjust the volume of the
current source to minimize the difference in
volume between different sources.
⁄
If you have increased the volume first, then reduced
•
the volume using the "VOL. Offset", the sound
generated if you suddenly switch to another source
may be extremely loud.
[Subwoofer Level] Adjusts the subwoofer
volume.
The setting is available when subwoofer is set
to "ON". See
[Loudness] Turns the loudness control
function On or Off.
If turned "ON", high and low tones are
automatically enhanced during low volume.
Settable only when zone function is set to Off.
See
[Stream Information] Displays the present
source information.
The stream (Dolby Digital, dts, Linear PCM,
MPEG, MP3, WMA or AAC) is displayed.
B64-4644-00_00_VW_E_En.indd 54
B64-4644-00_00_VW_E_En.indd 54
09.12.22 2:43:16 PM
09.12.22 2:43:16 PM