Kenwood DNX520VBT - Manual (Page 70)

70 DNX520VBT
Setup Menu
AV Interface Setup
You can set audio and visual (AV) interface
parameters.
Display the AV Interface screen 1
Touch [ ] > [ ] > [AV Interface]. (page 57)
Set each item 2
[AV-OUT] Selects an AV source to be output at
the AV OUTPUT port. ( "AV-IN1")
[R-CAM Interrupt] Sets a method to switch to
the rear view camera video display.
(
"OFF")
"ON": Switches to the rear camera video
display when "Reverse" gear is engaged.
"OFF": The monitor does not switch to the
rear view camera video display even
when engaging the shift knob of car to
"Reverse".
⁄
When in DVD source, "AV-OUT" cannot be set to USB. •
When in USB source, "AV-OUT" cannot be set to DVD.
Navigation Setup
You can set Navigation parameters.
Display the Navigation Setup screen 1
Touch [ ] > [ ] > [Navigation]. (page 57)
Set each item 2
[NAV Interrupt Speaker] Selects speakers
used for voice guidance of the navigation
system.
(
"Front All")
"Front L": Uses the front left side speaker for
voice guidance.
"Front R": Uses the front right side speaker for
voice guidance.
"Front All": Uses both front speakers for voice
guidance.
[NAV Voice Volume] Adjusts the volume for
voice guidance of the navigation system.
(
"25")
[NAV Mute] Mutes the volume during voice
guidance of the navigation system.
(
"ON")
When turned "ON", the volume level drops for
voice guidance.
B64-4644-00_00_VW_E_En.indd 70 B64-4644-00_00_VW_E_En.indd 70 09.12.22 2:43:26 PM 09.12.22 2:43:26 PM