Kenwood DPX305U - Manual (Page 13)

English | 13
Removing the Unit
Removing the Unit
1
Remove the trim plate by referring to the removal
procedure in the section plate>.
2
Insert the two extraction keys (Accessory 3) deeply
into the slots on each side, as shown.
Accessory 3
3
Lower the extraction key toward the bottom, and
pull out the unit halfway while pressing towards
the inside.
¤
• Be careful to avoid injury from the catch pins on the
extraction key.
4
Pull the unit all the way out with your hands, being
careful not to drop it.
Installing the Microphone
unit
1
Check the installation position of the microphone
(Accessory 4).
2
Remove oil and other dirt from the installation
surface.
3
Install the microphone.
4
Lay the cable up to the unit with it secured at
several positions using tape or the like.
⁄
• Install the microphone as far as possible from the
cell-phone.
DPX405BT only
Peel off the release coated
paper of double-face adhe-
sive tape to secure the
microphone on the place
shown above.
Adjust the direction of the
microphone to the driver.
Fix a cable with a commercial item of tape.
Accessory 4
B59-2160-00_00_13-2DIN_QSG_E_en.indd 13 12/11/21 15:04