Kenwood BD-7000 - Manual (Page 22)

Connecting the AC adapter
1 Plug the AC adapter cord in to the DC IN
terminal on the rear of the Player.
2 Plug the supplied AC cord into the AC adapter.
3 Then, plug into an AC outlet.
¤ CAUTION
• Use the AC adapter (AC-120500A) provided with
this product.
NOTE
• Place the Player close to the AC outlet, and keep the
power plug within reach.
• TO PREVENT RISK OF ELECTRIC SHOCK, DO NOT
TOUCH THE UN-INSULATED PARTS OF ANY CABLES
WHILE THE AC CORD IS CONNECTED.
• The AC adapter may become warm after long-time use.
This is normal and does not indicate malfunction.
• If you are not going to use this Player for a long period of
time, be sure to remove the AC cord from the AC outlet.
Before Starting Playback
Turning the Power On
Turning the power on
Press a on the remote control or on the Player to turn
on the power of the Player.
• The a (On/Standby) indicator lights green.
NOTE
• When you turn on this player for the first time after
purchase or when you turn on this player after you perform
“System Reset” (See page 39), the language setting screen
will be displayed, so please perform the language setting
(See step 4 of page 22).
Entering standby
Press a on the remote control or on the Player to
enter standby.
The system is using very weak current to maintain the
built-in memory. This is called Standby mode. When
system main unit is in this mode, you can turn it on
using the remote control.
• The a (On/Standby) indicator lights red.
• If you press a again immediately after entering standby,
the Player may not turn on. If this happens, wait for 10
seconds or more and then turn on the power again.
Indicators on the Player
a (On/Standby) indicator
Green on Power on
Red on Standby
3D indicator
Green on Video signal output is 3D images
(See page 23).
¤ CAUTION
• The power in this equipment will not be completely cut off
from the wall outlet when the standby switch is turned off.
Install the equipment so that the wall outlet is easily
accessible and, in case of emergency, immediately unplug
the power plug from the wall outlet.
Mains plug is used as the disconnect device, It shall remain
readily operable and should not be obstructed during
intended use.
(Continued on the next page)
21
Playback
a
a (On/Standby) indicator
AC adapter
AC cord
3D indicator
BD-7000_CD-ROM_en_r2.6.indd 21 BD-7000_CD-ROM_en_r2.6.indd 21 10/10/07 9:07 10/10/07 9:07