Kenwood NX-800E - Manual (Page 29)

2
VGS-1 OPTIONAL VOICE GUIDE & STORAGE UNIT
v
oice
r
ecorder
The voice recorder allows you to record conversations and create voice memos.
■ Auto Recording
If activated, the auto recorder will continuously record all transmitted and
received signals. The recording storage area retains only the last 30 seconds
of recording.
■ Voice Memos
To record a voice memo for later playback:
1 Press the key programmed as Voice Memo, press and hold the key
programmed as Playback, or access the Menu {page 9}.
• The duration of recording memory will appear on the display and begin counting
down.
2 Speak into the microphone to record your memo.
3 Press to end the recording and store it in memory.
• If the memory becomes full, recording will stop and the voice memo will be
stored in memory.
■ Auto Reply Message
You can set the transceiver to automatically respond to Individual Calls while
using FleetSync/NXDN.
1
Press the key programmed as Auto Reply Message to enter Auto Reply
Message mode.
2 When you receive an Individual Call, the transceiver will send an automatic
response to the caller after 3 seconds, and “GREETING” appears on the
display.
• If you are available to receive the call, press any key to cancel the auto
response.
• If there is memory available on your transceiver for recording, “I am not available.
Leave your Message.” will be sent to the caller and they can leave a recorded
message. When a message is stored on your transceiver, “Msg Rcvd” appears
on the display.
• If no memory is available on your transceiver, “I am not available” will be sent to
the caller and “ MEMORY FULL” appears on the display.