Kenwood NX-800E - Manual (Page 22)

4
FleetSync is an Alphanumeric 2-way Paging Function, and is a protocol owned by
Kenwood Corporation.
Note: This function is available only in analog operation.
S
elcAll
(S
elecTive
c
Alling
)
A Selcall is a voice call to a station or group of stations.
■ Transmitting
1 Select your desired zone and channel.
2 Press the key programmed as Selcall or Selcall + Status to enter Selcall
mode.
3 Press / to select the station you want to call.
• If you are using a microphone keypad and Manual Dialing is enabled, you can
directly enter the station ID.
4 Press the PTT switch and begin your conversation.
■ Receiving
An alert tone will sound and the transceiver will enter Selcall Mode. The
calling station’s ID will appear when a Selcall is received. You can respond to
the call by pressing the PTT switch and speaking into the microphone.
■ Identification Codes
An ID code is a combination of a 3-digit Fleet number and a 4-digit ID number.
Each transceiver has its own ID.
• Enter a Fleet number (00 ~ 349) to make a group call.
• Enter an ID number (1000 ~ 4999) to make an individual call in your fleet.
• Enter a Fleet number to make a call to all units in the selected fleet (Fleet call).
• Enter an ID number to make a call to the selected ID in all fleets (Supervisor call).
• Select “ALL” Fleet and “ALL” ID to make a call to all units (Broadcast call).
S
TATuS
m
eSSAge
You can send and receive 2-digit Status messages which may be decided in your
talk group. Messages can contain up to 6 alphanumeric characters. Status
messages range from 0 to 99 (80 ~ 99 are reserved for special messages).
A maximum of 5 received messages (combined status messages and short
messages) can be stored in the stack memory of your transceiver.
■ Transmitting
1 Select your desired zone and channel.
2 Press the key programmed as Status to enter Status mode (proceed to
step 5) or Selcall + Status to enter Selcall mode (proceed to step 3).
FleetSync: ALPHANUMERIC 2-WAY PAGING FUNCTION