Kenwood NX-800E - Manual (Page 15)

7
BASIC OPERATIONS
S
wiTching
p
ower
on/oFF
Press and hold the switch for approximately second to turn the transceiver
power ON. Press and hold the switch again to turn the transceiver OFF.
■ Transceiver Password
If the transceiver is password protected, “PASSWORD” will appear on the
display when the power is turned ON. To unlock the transceiver, enter the
password:
1
Select a character using / .
• If you are using a microphone keypad, you can enter the password direclty.
2 Press to enter the selected character.
• This step is unnecessary when using the keypad.
3 Repeat steps and 2 to enter the entire password.
• Press or # to delete a character. Press and hold or # to delete all
characters.
4 Press or to confirm the entry.
• If you enter an incorrect password, an error tone sounds and the transceiver
remains locked.
• The password can contain a maximum of 6 digits.
A
djuSTing The
v
olume
Press the keys programmed as Volume Up/ Volume Down to adjust the volume.
S
elecTing A
Z
one And
c
hAnnel
/g
roup
id
Select the desired zone using / (default). Each zone contains a group of
channels.
Select the desired channel/group ID using / (default). Each channel/group ID
is programmed with settings for transmitting and receiving.
• You can toggle the display between the zone and channel/group ID names and number
by pressing the key programmed as Display Format, or by accessing the Menu {page 9}.
Note: If the default settings for / and / have been changed, use the appropriate keys to
select the zone and channel/group ID.
T
rAnSmiTTing
1 Select the desired zone and channel/group ID.
2 Press the key programmed as Monitor or Squelch Off to check whether or
not the channel is free.
• If the channel is busy, wait until it becomes free.