Kenwood NX-800E - Manual (Page 23)

5
3 Press / to select the station you want to call.
• If Manual Dialing is enabled, you can enter the station ID by using the
microphone keypad, or by using / . When using / , cycle through the digits
to select a digit, then press to set the digit and move the cursor to the right.
Repeat this process until the entire ID is entered.
4 Press to enter Status mode.
5 Press / to select the status you want to transmit.
• If Manual Dialing is enabled, you can enter the status ID by using the
microphone keypad, or by using / (refer to step 3, above).
6 Press the PTT switch or to initiate the call.
• “<>” appears on the display when the status has been
successfully transmitted.
■ Receiving
The icon will flash and a calling ID or text message will appear when a
Status call is received. Press any key to return to normal operation.
■
Reviewing Messages in the Stack Memory
1 Press the key programmed as Stack, or press and hold the key
programmed as Selcall, Status, or Selcall + Status to enter Stack mode.
• The last received message is displayed.
2 Press / to select the desired message.
• Message types are identified as follows:
I: Caller ID, S: Status Message, M: Short Message
• Press and hold for second to cycle the display information as follows:
ID Name > Status/Short Message > CH/GID > Time Stamp
3 Press to return to normal operation.
• To delete the selected message, press or #. To confirm the deletion, press
or .
• To delete all messages, press and hold or # for 1 second. To confirm the
deletion, press or .
S
horT
/l
ong
m
eSSAgeS
Received short messages are displayed the same as Status messages and are
stored in the same stack memory.
To send short messages, and to send and receive long messages, you must
connect the transceiver to a PC. Ask your dealer for details.
gpS r
eporT
To send your location data, you must first connect a GPS unit to the transceiver.
GPS data can be manually transmitted by pressing the key programmed as Send
the GPS data , or by accessing the Menu {page 9}. If set up by your dealer, GPS
data may be automatically transmitted at a preset time interval.