Kenwood KOS-A210 User Manual

Page 33

English

Install Bracket (Accessory 6).

When using spacer (Accessory 5)

Accessory!
(Ø4 X 16.5)

When not using spacer (Accessory 5)

Accessory@
(Ø4 X 4.5)

You can also install it using a double-sided tape

(Accessory ~)

When using spacer (Accessory 5)

Accessory#

When not using spacer (Accessory 5)

Accessory#

⁄

• Install the controller using the screws (Accessory-/=)

when it cannot be secured firmly using the double-sided
tape.

• Thoroughly wipe away and dust or grease from the

installation location using a cloth which has been soaked
in a neutral cleaning agent and wrung out. Attach after
allowing the installation location to dry.

• Do not attach the double-sided tape more than once or

touch the adhesive with your fingers as this will weaken its
adhesive strength.

• If the temperature of the surface of the installation location

is low, warm it up using a heater or other means before
attaching the stand. Low temperature may weaken the
adhesive the double-sided tape.

Install the controller to bracket (Accessory 6).

Accessory6

Controller

⁄

• When you remove the controller from bracket (Accessory

6), turn the controller while pressing the release button.

Release button

B64-4455-00_00_KOS-A210_E.indd 33

09.2.18 2:28:03 PM