Installation – Kenwood KTC-D600E User Manual
Page 17

English 17
Installation
Installing the Remote Control Sensor
Paste the remote control sensor to the dashboard.
1
Remove the paper from double-stick tape and paste
it on the back of the remote control sensor.
2
Wipe the dirt and oil off from the installation area
and paste the remote control sensor
to the
dashboard.
Remote control sensor
• Wipe oil and dirt off from the installation surface.
• Avoid area where there is direct sunlight or close to TV
monitor because the remote control signals may be
affected.
Inserting CA Card and CAM
Insert the CA card (Conditional Access card) and CAM
(Conditional Access Module) into the card slot.
• CA card (Conditional Access card) and CAM (Conditional
Access Module) is optional (sold separately).
• When CA card and CAM are inserted in this unit, CA card
and CAM protrude from a unit. Take well care about an
installation position.
• When you insert or draw out a CA card and CAM in the
slot of this unit, be sure to ACC OFF.
• When you insert or draw out a CA card and CAM, keep it
horizontally.
• Eject or insert the CA card or CA module before turning
on the power.
• Do not leave this device inside the car. The temperature
inside the car may rise rapidly, and CA card or other parts
may be deformed or become unusable due to the heat
inside the car.
There is also the danger of theft.
1-KTC-D600E_ENG_1018.indd 17
2010-10-18 �� 1:48:59