Kenwood KTC-D600E - Manual (Page 16)

16 KTC-D600E
Installing the Main Unit
The Digital TV Tuner (main unit) can be installed
by securing it to the pile carpet with Velcro or by
screwing it on to a commercially available audio
board.
• There are various terminals on the main unit. Leave some
space to connect cables on the terminal side of the main
unit.
• Do not place anything on top of the main unit. This can
cause product failure.
• Do not install the main unit stacked with other units.
• Install the main unit at least 1.5m away from radio
antenna.
Installing with Screw
1
Use a tapping screw to secure the bracket to the
vehicle's audio board (commercial product).
• When drilling holes in the vehicle, be sure there is nothing
on the other side.
Damage to cables or pipes can cause accident or
malfunction.
Accessories Installation
 Wiring harness (6m) ........................... 1
 Remote Control Sensor (6m) ........ 1
 TV Interface Cable (6m) ................... 1
 Bracket ........................................................ 2
 Screw (M2.6 × 5mm) ......................... 4
 Screw (φ4 × 16mm) ........................... 4
 Remote Control Unit ........................ 1
Audio board
(commercial product)
Screw (φ4×16mm) 
Screw
(M2.6×5mm) 
Screw (M2.6×5mm) 
Bracket 
Digital TV Tuner
Bracket 
1-KTC-D600E_ENG_1018.indd 16 2010-10-18 �� 1:48:59