References – Kenwood DDX5901HD User Manual
Page 73
ENGLISH
73
.
e
c
i
v
e
d
h
t
o
o
t
e
u
l
B
e
h
t
h
t
i
w
r
i
a
p
t
o
n
s
e
o
d
t
i
n
u
e
h
T
• For devices compatible with Bluetooth 2.1:
• For devices compatible with Bluetooth 2.0:
Enter the same PIN code for both the unit and
target device. If the PIN code of the device is not
indicated in its instructions, try “0000” or “1234.”
Echo or noise occurs.
• Adjust the microphone unit position.
• Adjust the echo volume or noise reduction
The unit does not respond when you try to copy
the phone book to the unit.
• You may have tried to copy the same entries (as
stored) to the unit.
Notice/Caution on using Bluetooth
devices
(Only for DDX8901HD/DDX7701HD/
DDX5901HD)
IC (Industry Canada) Notice
This device complies with Industry Canada licence-
exempt RSS standard(s).
Operation is subject to the following two conditions:
(1) This device may not cause interference, and (2)
this device must accept any interference, including
interference that may cause undesired operation of
the device.
The term “IC: ” before the certification/ registration
number only signifies that the Industry Canada
technical specifications were met.
CAUTION
This equipment complies with FCC/IC radiation
exposure limits set forth for an uncontrolled
environment and meets the FCC radio frequency
(RF) Exposure Guidelines in Supplement C to OET65
and RSS-102 of the IC radio frequency (RF) Exposure
rules. This equipment has very low levels of RF
energy that it deemed to comply without maximum
permissive exposure evaluation (MPE). But it is
desirable that it should be installed and operated
keeping the radiator at least 20 cm or more away
from person’s body (excluding extremities: hands,
wrists, feet and ankles).
Under Industry Canada regulations, this radio
transmitter may only operate using an antenna of a
type and maximum (or lesser) gain approved for the
transmitter by Industry Canada. To reduce potential
radio interference to other users, the antenna type
and its gain should be so chosen that the equivalent
isotropically radiated power (e.i.r.p.) is not more than
that necessary for successful communication.
• Contains Transmitter Module
FCC ID : YZP-RBFAC21XX
• Contains Transmitter Module
IC: 7414A-RBFAC21XX
Specifications
❏
Monitor section
Picture Size (W x H)
DDX8901HD/DDX7701HD/DDX7071BT :
6.95 inches
(diagonal) wide
156.6 mm x 81.6 mm (6-3/16" x
3-3/16")
DDX5901HD :
6.1 inches
(diagonal) wide
136.2 mm
x 72 mm (5-6/16" x
2-13/16")
Display System
Transparent TN LCD panel
Drive System
TFT active matrix system
Number of Pixels 1
152 000 (800H × 480V × RGB)
Effective Pixels
99.99%
Pixel Arrangement
RGB striped arrangement
Back Lighting
LED
❏
n
o
i
t
c
e
s
r
e
y
a
l
p
D
V
D
D/A Converter
24 bit
Audio Decoder
Linear PCM/Dolby Digital/MP3/
WMA/AAC
Video Decoder
MPEG1/MPEG2/DivX*
Wow & Flutter
Below Measurable Limit
Frequency Response
96 kHz Sampling: 20 Hz to 20 000 Hz
48 kHz Sampling: 20 Hz to 20 000 Hz
44.1 kHz Sampling: 20 Hz to 20 000 Hz
Total Harmonic Distortion
0.010% (1 kHz)
Signal to Noise Ratio
94 dB (DVD-Video 96 kHz)
Dynamic Range
91 dB (DVD-Video 96 kHz)
Disc Format
DVD-Video/DVD-VR/VIDEO-CD/
CD-DA
Sampling Frequency
44.1 kHz/48 kHz/96 kHz
Quantifying Bit Number
16/20/24 bit
* Only for DDX7071BT.
REFERENCES
DDX_Mid_K.indb 73
2014/01/23 15:45