Kenwood DDX5901HD - Manual (Page 62)

CONNECTION/INSTALLATION
Connection
❏ Connecting wires to terminals
(ACC)
(BATT)
(GND)
62
Page 64 Pages 63 – 64
Page 65
USB terminal:
Pages 63 – 64
10 A fuse
Ignition key switch
Fuse box
Battery
Connect to the vehicle’s reverse lamp harness when
using the optional rear view camera.
Connect to the vehicle’s parking
brake detection switch harness.
• For best safety, be sure to
connect the parking sensor.
Depending on what antenna you are using, connect either to the control
terminal of the motor antenna, or to the power terminal for the booster
amplifier of the film-type antenna. (Max. 300 mA, 12 V)
When using the optional power amplifier, connect to its power control terminal.
Not used.
To use the steering wheel remote control feature, an exclusive remote adapter
(not supplied) matching your car is required.
To car light control switch
To car chassis
Purple with white stripe
(Reverse sensor wire)
Light green (Parking
sensor wire)
Connect SiriusXM Connect Vehicle Tuner
(commercially available). See page 64.*
2
3
1
White ª / White with black stripe · : To front speaker (left)
Gray ª / Gray with black stripe · : To front speaker (right)
Green ª / Green with black stripe · : To rear speaker (left)
Purple ª / Purple with black stripe · : To rear speaker (right)
Blue (Antenna control wire)
Blue with white stripe (Power control wire)
Brown (Mute control wire)
Light blue with yellow stripe (Steering remote control wire)
Orange with white stripe (Dimmer control wire)
Red (Ignition wire)
Yellow (Battery wire)
Black (Ground wire)
* 1 Only for DDX7071BT.
* 2 Only for DDX8901HD/DDX7701HD/DDX5901HD.
* 3 If no connections are made, do not let the cable come out from the
tab.
Connect the antenna
cord to the antenna
terminal.
* 3
Connect to the vehicle’s steering remote harness.
Contact your Kenwood dealer for details.*
1 7
DDX_Mid_K.indb 62 2014/01/23 15:45