Summers 4-Rank Superweeder User Manual
Page 81
SECTION 4 - HARROW PACKER
4-15
CABLE PULL BRACKETS
Under severe conditions (heavy machine draft due to deep penetration or high field speed)
cable brackets may slide on drawbar wing tube, resulting in improper cable adjustment. The
recommended solution for this is to relocate cable pull brackets at desired position and weld
a stop on drawbar next to cable pull brackets.
FIELD TO TRANSPORT POSITION
1. Stop in a level area and back tractor up to provide slack in pull cables.
2. Open manual lock valve on auto-fold lock cylinder. Fully extend auto-fold lock cylinder.
3. Fully retract hydraulic depth adjustment cylinders (if so equipped).
4. Fully retract main lift cylinders raising sections.
5. While machine is resting on its transport wheels, drive tractor forward. Wings should fold to trans-
port position.
NOTE: Transport wheels must rotate against “toe-in” adjustment cap screws and follow directly
behind knuckles. Transport wheel “toe-in” can be adjusted by moving outside 3/4” adjustment set
screws (8X0665, page 4-5). “Toe-in” and proper lubrication of pivot will make it easier to unfold
machine into field position. Wing support wheels must not contact in transport position.
6. IMPORTANT: Install transport locks.
UNHITCHING MACHINE
1. Park machine on a level area. Block wheels to prevent machine from rolling.
2. Follow steps outlined in WARNING – NEGATIVE HITCH WEIGHT on page 1-2.