Summers 4-Rank Superweeder - Manual (Page 42)

NOTE: Hydraulic Tine Angle option can be used in upper three manual height adjustment settings
ONLY. (See page 2-10).
FIELD TO TRANSPORT POSITION
1. Stop in a level area and back tractor up to provide slack in pull cables.
2. Open manual lock valve on auto-fold lock cylinder. Fully extend auto-fold lock cylinder.
3.
Fully retract Hydraulic Depth Adjust cylinders.
4. Fully retract lift cylinders raising sections.
5. While machine is resting on its transport wheels, drive tractor forward. Wings should fold to trans-
port position. NOTE: Transport wheels must rotate against “toe-in” adjustment cap screws and
follow directly behind knuckles. Transport wheel “toe-in” can be adjusted by moving outside 3/4”
adjustment set screws (8X0665, Page 2-5). “Toe-in” and proper lubrication of pivot will make it
easier to unfold machine into field position. Wing support wheels must not contact in transport
position.
6. IMPORTANT: Install transport locks.
UNHITCHING MACHINE
1. Park machine on a level area. Block wheels to prevent machine from rolling.
2. Follow steps outlined in WARNING – NEGATIVE HITCH WEIGHT on page 1-2.
SUMMERS SUPERHARROW PLUS (SH+) PERFORMANCE ADJUSTMENTS:
NOTE: These are suggested initial settings, further adjustments may be necessary to match field
conditions.
SECTION 2 - SUPERHARROW PLUS
2-30