Summers 4-Rank Superweeder - Manual (Page 35)

12. Install hydraulic fittings and hoses as shown in hydraulic hose layout drawing (Page 2-22). Se-
cure hoses next to existing hydraulic hoses on drawbar and hitch with clamps and nylon ties
provided. Allow ample hose at hinge points to avoid pinching or stretching when folding and
unfolding machine.
Route hose through loop at rear of hitch to prevent ground contact in transport position.
The Hydraulic Tine Angle option utilizes a master – slave hydraulic system. Oil is delivered to
base end of the largest cylinder (4-1/2” diameter located on left hand wing) and returns to tractor
from rod end of smallest cylinder (3-1/2” diameter located on machine center).
SECTION 2 - SUPERHARROW PLUS
2-23