VariZoom VZTOC-ZFi3 - Manual (Page 7)

- 7 -
is not a defect or a problem. The bar graph is just displaying the “relative” input
force on the toggle, and the zoom motor reaches its maximum speed well before the
indicator reaches the end of the bar, so you’ll get equal speed control in both
directions regardless of the indicator’s maximum excursion.
Speed is adjusted the same way, and will control how quick the motor responds to the
Toggle.
Press the “ ” button in the top left corner of the screen to return to the Home Screen.
3. Iris Setup Menu
From the Iris Setup screen, you can set the iris motor and
slider limits, reverse motor and slider response direction, as well as adjust smoothing.
To set a limit, simply move the slider to the where you want the limit, and tap the “set
limit” button. Once a limit is set, the “Set Limit” button will then read “Clear Limit”.
Tap this button to clear the limit.
Motor and slider response direction is changed by selecting the “Dir+” button located
under either “Motor” or “slider”. This will change the button to be “Dir-“. Select it
again to change it back.
Smoothing is adjusted by selecting the “set” button next to the “smooth” indicator.
Adjust the “Lens Smoothing” to the desired smoothing level, then press “OK”
Note: The
more smoothing you have, the more delay will show between motor and slider
response.
Press the “ ” button in the top left corner of the screen to return to the Home Screen.