Red Lion EPAX/MPAX - Manual (Page 7)

SHROUD INSTALLATION PROCEDURE
Installing The Shroud On An EPAX Display In A NEMA 4/IP65 Enclosure Or Panel
1. Place a gasket over the studs extending from the rear of the
front panel of the Display.
2. Orient the shroud as shown in Figure 6, and place it over the
display. The studs of the display should now be protruding
through the rear of the shroud.
3. Place the other gasket over the studs.
4. Install the unit into the panel or enclosure using the #10-32
keps nuts that are supplied with the Display. Tighten the nuts
firmly.
DIMENSIONS FOR THE EPAX DISPLAY SHROUD
The optional EPAX Display Shroud enhances the readability of the
Displays that are installed in areas with high intensity overhead light
sources. The Shroud can be used with the EPAX Display in any
installation, (panel mount, NEMA 4/IP65 Enclosure, or Universal
Mounting Bracket). When properly assembled, the Shroud will not
affect the integrity of a NEMA 4/IP65 installation. The Shroud
weighs 1.0 pounds (0.45 Kg).
ASSEMBLY AND INSTALLATION PROCEDURE
1. Install the two mounting channels on the enclosure housing using
the four #8-32 screws provided and then insert the strut nuts
(provided). Invert enclosure if base mounting.
2. If the wiring is to be routed through the housing, make sure that
the mounting channels are oriented properly before drilling, so
the Display will be readable. Wiring is generally brought into the
right side of the housing or rear panel, closest to the terminals of
the MPAX module. Drill the proper size hole in the housing or
rear panel for the wiring connector or sealed conduit fitting and
attach the fitting(s)
3. Before installing the Display into the housing, be sure that the
mounting channels are oriented properly for the type of
installation planned. Place the gasket that is supplied with the
Display over the studs extending from the front panel of the
display.
4. If using the shroud, refer to the Shroud Installation Procedure.
Place the Display with gasket through the holes in the housing as
shown at right. Working back and forth across the stud pattern,
install the #10-32 keps nuts supplied with the Display on the
studs. Tighten firmly.
5. Mount the housing, using the strut nuts and steel ¼-20 UNC
bolts and washers, as shown in figure 4.
6. Connect the wires to the Display per the instructions included
with the personality board.
7. Remove the center section of the rear panel gasket. Apply the
gasket to the rear panel of the enclosure by inserting the #8-32
screws through the panel and into the holes in the gasket.
Position the panel on the housing, start all of the screws, then
firmly tighten them in a pattern working back and forth across
the rear panel.
7
EPAX
MOUNTING
CHANNEL
TYP. 2
#8-32 SCREWS
TYP. 4
FRONT PANEL GASKET *
HOUSING
#8-32 SCREWS
TYP. 16
#10-32
KEPS NUTS *
TYP. 14
STRUT NUT
TYP. 2
REAR PANEL GASKET
REAR PANEL
1/4-20 x 1"
SCREW & WASHER
7.60
(193)
25.12 (637.9)
3.65
(92.7)
EPAX
SHROUD
GASKET
FRONT PANEL GASKET *
PANEL OR NEMA 4 ENCLOSURE
#10-32
KEPS NUTS *
TYP. 14
Figure 5
Figure 4
Figure 6
Nema 4/IP65 Shroud Installation
* Supplied with EPAX.
* Supplied with EPAX.
DIMENSIONS In inches (mm)