HighPoint RocketRAID 2300 - Manual (Page 48)

RocketRAID 230x Driver and Software Installation
1. Enter a name for the task.
2. Configure the frequency for the task.
3. Set the duration for the task.
4. Check the “Enable the task” option to activate this task.
5. Click “Finish”.
Modify a Scheduled Task
This command is used to change settings for a scheduled task. To Modify a Task
Schedule:
1. Select a task from the Task schedule list.
2. Click the “Modify” button on the toolbar, and modify the task settings in the
popup window.
Delete a Scheduled Task
This command is used to delete a Scheduled Task for the selected remote system. To
delete a Task Schedule:
1. Select a task from the Task schedule list.
2. Click the “Delete” button on the toolbar.
10 - Configuring Remote Systems
Then HighPoint RAID Management Console manages a RAID controller through a
connection to the HighPoint RAID Management Service, which runs on the system
where the RAID host adapter is physically installed. This type of system is referred
to as a “remote system”.
Note: What the software classifies as a “remote system” may not always be an actual
remote computer. In some configurations, the local computer hosts both the RAID
host adapter and Management Service. The local system, in these cases, is still
generically referred to as a “remote system”.
4-19