HighPoint RocketRAID 2300 - Manual (Page 28)

Use the drop down menus to enable or disable controller functions.
Using the DOS mode utility (load.exe):
Load xxx.xxx –c
Note: “xxx.xxx” refers to the BIOS image file.
A BIOS menu similar to the BIOS setup utility will be displayed.
This sub-menu allows the administrator to enable/disable various controller
functions.
Several of the more common functions are described below:
Keyboard Timeout (diag.exe) / Stop on Error (hptflash.exe) – disabling this
option will prompt the card to automatically skip error messages during
bootup (broken array warnings), if the administrator does not input the
“Control + H” command to access the BIOS menu.
EBDA Reallocation – this function refers to “Extended BIOS Data Area”.
Disabling this feature may remedy boot problems associated with
motherboards that halt after the RR230x BIOS screen is displayed.
INT13 – The card’s boot function. Disabling this feature removes the card’s
ability to boot the system. This may be useful for systems that utilize
multiple bootable controllers – some motherboards may not be able to load
the BIOS of each device during bootup, which may impair the system’s
ability to boot from a specific device.
Control-H – Allows the administrator to adjust the time allotted for hard disk scan-
ning/detection. This may be useful for hard disks that do not support Staggered
Drive Spinup.
RocketRAID 230x BIOS Utility
3-9