HighPoint RocketRAID 2522 - Manual (Page 74)

Mac OSX Driver and RAID Management Software
You will then be notified that a reboot is needed to install the software. Click
“Continue Installation”.
The driver will then be installed into the system. Click “Restart” to restart the system.
After the system restarts, you can use a web browser to configure the controller and
setup RAID arrays. Use the MacOSX Disk Utility to create partitions the RAID
arrays.
Web RAID Management Interface
Note: To use the web-based RAID management interface, a web browser with XML
support is required, e.g. Internet Explorer 6.0, Mozilla or FireFox.
To run the management interface, start your browser and enter the following URL
address:
https://localhost:7402
If you are managing a remote system please change “localhost” to the server’s host
name or IP address.
The default user name is “RAID” and the initial password is “hpt”. You can change
the password after you have logged in.
Note: the login information is saved in /etc/hptuser.dat. If you forget the password
you can remove this file to reset the password.
If you can’t connect to the local system, please check and make sure a process named
hptsvr is running. If hptsvr is not running, you can start it manually by using the
following command (from a terminal window)
“/Library/StartupItems/Hptsvr/hptsvr”.
If you can’t connect to a remote system, make sure hptsvr is running on that system.
and you can access the remote system via TCP/IP connection. If you have a firewall
configured, make sure TCP port 7402 is not blocked.
Uninstalling
To uninstall the driver and management software, double click the “rr2522-MacOSX-
universal-vxxx-” file.
7-2