Vaisala WAC155 - Manual (Page 43)

Chapter 4 ________________________________________________________________ Operation
VAISALA _______________________________________________________________________ 41
Example:
>setmea offset 0.318
GAIN = 0.09853
OFFSET = 0.31800
POWERSAVE = 1
ALLOWEDSPDCHANGE = 10.0
MAXINVALIDSPDCOUNT = 2
>
SETCOM
The SETCOM command configures the communication ports. Default
communication port settings are 9600-n-8-1.
SETCOM [portnumber] [baudrate] [databits] [stopbits] [parity]
[txddelay]
Example:
>setcom baudrate 9600
BAUDRATE = 9600
DATABITS = 8
PARITY = NONE
STOPBITS = 1
TXDDELAY = 30
>
where
portnumber= The number of the COM port to configure, 0 or 1. If
omitted, the configuration will apply to the current port
in use.
baudrate = The baud rate of the port. Possible values: 300 600 1200
2400 4800 9600 19200
databits = The number of data bits, 7 or 8
stopbits = The number of stop bits, 1 or 2
parity = The parity to be used. Possible values: ODD EVEN
NONE
txddelay = The RS-485 half-duplex transmission turn-around delay
in milliseconds, range 0 .. 200
value = The value for the option.