Anthem Audio AVM 50 - Manual (Page 51)

43
3.14 LOCKOUT / PASSWORDS
Passwords are used to protect the saved User and Installer settings. Once you have set a password, it can
also be used as a Lockout to prevent settings from being changed by anyone without one of the passwords.
Lock Settings:
When set to ‘Yes’, entry to the Setup Menu is prevented unless the password is entered first.
Set User or Installer Password:
Whether or not settings are locked, if a password is set, it will still be required to save changes to User or
Installer settings. Pick a 4-digit number that you will remember easily. To enter it, use the 0 – 9 keys on the
Remote Control (password cannot be entered from the Front Panel). To change a password, enter the old
one, then enter (and confirm) the new one. Write down your password in case it’s forgotten in the future!
Example 1: Set User Password (Remote Control only).
• Enter the Setup Menu. You must enter the USER or INSTALLER Password if there is one.
• Go to ‘14. LOCKOUT / PASSWORDS’ and press SELECT.
• Press the key to go to ‘b. SET USER PASSWORD’.
• Press SELECT. You will be asked to enter a four digit number. Use the 0 – 9 keys to do so. If you are
changing your Password you will be asked to enter your old Password first. You will also be asked
to confirm your new Password (re-enter your new Password).
Clearing the User Password: When asked for your new Password, press the key four times. You will
also be asked to confirm your new Password – press the key four times again. Message will then say
‘User Password Removed’.
Example 2: Lock Settings (Remote Control only).
• Enter the Setup Menu. Go to ‘14. LOCKOUT / PASSWORDS’ and press SELECT.
• Upon entering this menu item, ‘a. LOCK SETTINGS’ will be highlighted in red.
• Press SELECT. You will be asked to enter your Password. Either the USER or INSTALLER Password
will work. Use the 0 – 9 keys to do so.
• Use the buttons to change to ‘Yes’ or ‘No’.
• Press SELECT or BACK.
3. SETUP MENU
continued …
14. LOCKOUT / PASSWORDS
a. LOCK SETTINGS
b. SET USER PASSWORD
c. SET INSTALLER PASSW'D