Lighting and operating label – State SBL85 390NE A User Manual
Page 21
19
Servicing should only be performed by a Qualified Service Technician
LIGHTING AND OPERATING LABEL
S
N
O
I
T
C
U
R
T
S
N
I
G
N
I
T
A
R
E
P
O
G
N
IT
A
R
E
P
O
E
R
O
F
E
B
D
A
E
R
Y
T
E
F
A
S
R
U
O
Y
R
O
F
1.
2.
STOP! Read the safety information
above on this label.
Set the ON/OFF switch on the control box to
the “OFF” position.
6. Turn on all electrical power to the appliance.
7. Set the ON/OFF switch on the control box to
the “ON” position.
8. Set the thermostat to the desired setting.
9. If the appliance will not operate, follow the
instructions “TO TURN OFF GAS TO
APPLIANCE” and call your technician or gas
supplier.
Wait five (5) minutes to clear out any gas.
If you then smell gas, STOP! Follow “B”
in the safety information above on this label. If
you don’t smell gas, go to the next step.
3. Set the thermostat to the lowest setting.
4. This appliance is equipped with a device which
automatically lights the burner.
DO NOT TRY TO LIGHT THE BUNER BY HAND.
5.
CAUTION: Hotter water increases the risk
of scald injury. Consult the instruction
manual before changing temperature.
WARNING: TURN OFF ALL ELECTRIC
POWER BEFORE SERVICING.
FLAMMABLE
WARNING:
If you do not follow these instructions exactly, a fire or
explosion may result causing property damage, personal injury
or loss of life.
BEFORE OPERATING: ENTIRE SYSTEM MUST BE FILLED WITH WATER AND AIR PURGED FROM ALL LINES.
A.
B.
This appliance does not have a pilot. It is equipped with
an ignition device which automatically lights the burner.
Do not try to light the burner by hand.
C. Use only your hand to push the control buttons. Never use
tools. If the control buttons will not push in, don’t try to
repair them, call a qualified service technician. Force or
attempted repair may result in a fire or explosion.
D. Do not use this appliance if any part has been under water.
Immediately contact a qualified installer or service agency
to replace a flooded water heater. Do not attempt to repair
the unit. It must be replaced!
BEFORE OPERATING smell all aroung the area for gas.
Be sure to smell next to the floor because some gas is
heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
Do not try to light any appliance.
Immediately call your gas supplier from a neighbor's
phone. Follow the gas suppliers instructions.
If you cannot reach your gas supplier, call the fire
department.
Do not touch any electric switch;
do not use any phone in your building.
2. Set the ON/OFF switch on the control box to
the “OFF” position.
1. Set the thermostat to the lowest setting.
3. Turn off all electrical power to the appliance
if service is to be performed.
TO TURN OFF GAS TO APPLIANCE
ON
OFF