Outback Power Systems GS8048 Operator Manual - Manual (Page 44)

Troubleshooting
42 900-0020-01-00 Rev B
Table 5 Warning Troubleshooting
Message Definition Possible Remedy
Fan Failure The inverter’s internal cooling fan is not
operating properly. Lack of cooling may
result in derated inverter output wattage.
Turn the battery disconnect off, and then on, to
determine if the fan self-tests. After this test,
contact OutBack Technical Support for the next
step. (The next step will depend on the results of
the test.)
NOTE: The system can continue to operate if the
inverter can be run at reasonable levels. External
cooling may also be applied.
Transformer
(in Temps menu)
Displays the ambient temperature around the
inverter’s transformer.
In the MATE3, these values are given in degrees
Celsius.
If any reading does not seem to reflect the
inverter’s temperature or conditions, contact
OutBack Technical Support (see inside front cover
of this manual).
Output FETs
(in
Temps menu)
Displays the temperature of the FETs (Field
Effect Transistors) and heat sink.
Capacitors
(in
Temps menu)
Displays the temperature of the inverter’s
ripple capacitors.