Night Owl LTE-168500 - Manual (Page 53)

52
16.2 PTZ Menu
Use the PTZ setup menu to configure settings for a connected PTZ camera
(not included).
To access the PTZ Setup menu select Camera from the Main Menu, and
then select PTZ from the Camera menu.
Please refer to the documentation of your PTZ camera for proper settings.

Channel: Select the channel to make adjustments.

Protocol: Select PELCO-D, or PELCO-P for the selected channel.

Baud Rate: Select 1200, 2400, 4800, or 9600.

Data Bit: Select 5, 6, 7, or 8.

Stop Bit: Select 1 or 2.

Parity: Select ODD, EVEN, MARK, SPACE, or NONE.

Address: Enter an address from 001~255.

Cruise: Select Enable or Disable.

Copy To: This will copy the settings to another channel.
Please r
efer to your PTZ camera’s instruction manual for further
details. PTZ camera is not included.
Chapter 16 Camera Menu