GReddy AIR INTAKE SYSTEMS: Mitsubishi Lancer 2008-12 - Manual (Page 2)

Install housing and position grommets on housing to
factory fittings.
10
Make sure housing is secure on fittings.
11
Attach tab on housing to screw on ECU bracket. Make
sure nylon spacer is between tab and ECU. Secure tab
using M6 nut, wavy and flat washer. Tighten using
10mm socket or wrench.
12
Install filter and tighten using 5/16” nut driver. Tighten
all remaining clamps using 5/16” nut driver.
16
Install provided 5/8” hose to engine and tube.
Reconnect MAF sensor harness. Reconnect battery
terminals.
17
The installation of your Greddy Performance intake is
now complete. Please check all components and re-
tighten if necessary. Thank you for choosing Greddy!
18
Place filter in housing. Attach ram air assembly to
housing.
13
Attach elbow coupling with clamps to tube. Position
tube to throttle body and tab on tube to isolation mount.
14
With M6 nut, wavy and flat washer provided, secure
tab and tighten using 10mm socket or wrench.
15
Replacement Filter P/N:
61-90132
06-80501 Pg2
Accessories
Note: Filter Cleaning: When cleaning your TM
filter, be sure to use only “Restore Kit”
(P/N: TP-7016C TM cleaner only.)
TM cleaning:
see cleaning instruction sheet TF-9000I.
GReddy Performance Products
9 Vanderbilt, Irvine CA 92618
T: 949.588.8300 F: 949.588.6318
[email protected]
www.greddy.com